Also, within a model family the same serial number prefix may be used to produce a variety of different models, all in the same block of serial numbers. There are occasions when blocks of serial numbers have been manufactured out of sequence, sometimes years later. test fire, and if no misfires, then the headspace should be correct///once fitted from or to another gun, they most often drop right in, just do not want it TOO loose, gaps ( headspace issues) the proof is in the actual test firing of the gun.if it spins, turns, and locks up, and stays locked up ( in battery) your OK.simple work the action on the "UNLOADED" gun before shooting it.the overall length of the new cylinder should be the same as the one that came with the gun. Ruger does not necessarily produce firearms in serial number order. face and the rear of the barrel, so its NOT rubbing and you have about>004-.006 " of an inch, too much gap you can get 'blow by", then the other end, the bottom of the cartridges should NOT 'drag' against the recoil shield. Welcome to the forum, on any old model over 150,000 serial number range if you put the cylinder, and pull back ( cock the hammer) and it LOCKS up on every chamber, you should be good to go.look at the spacing in front of the cylinder, between the cyl.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |